TSUSH - The Smaller Ultimate Spool Holder

This is a small copycat version of the ultimate spool holder by terrago: https://www.thingiverse.com/thing:2047554

I remodeld it smaller because the original didn't fit my print bed well. I also added snap ins for a tighter fit that doesn't need glue.

Like with the original you will need two 608 bearings and 4 pieces. For convenience I added an stl that already contains two pieces.

If the holder is not stable enough for your liking, I recommend printing drofnas' adjustable support: http://www.thingiverse.com/thing:2199309

I'ts a good addition if you like to move your spools around while on the holder.

Print Settings

Printer:

Monoprice Select Mini

Rafts:

No

Supports:

No

Resolution:

0.4mm / 0.2625mm

Infill:

35%