Sunlu 3D Filament Dryer Box S1 Guide Remix

This remix of the original adds the following:

• Filled in back plate
• Screw holes that are counter-sunk

To get more information on print details, visit the original designers page.

Installation Parts:

• 2 Bolts - M3x12 (I used M3x16 for mine because it's what I had)
• 2 Nuts - M3
• 2 washers - M3 (anything about twice the size of the head)

Installing:

• Using the Sunlu Slot as a guide, place it and mark the drill holes with a sharpie.
• Using a 3/32" drill bit (it's a perfect size) drill both holes.
• Screw in a bolt into each hole to create the threads in the plastic, then back out the screw.
• Now install the Sunlu Slot with both bolts, place the washers and tighten down the nuts.