Headset hanger

To simplify the print, I made this model rigid so, in order to have a nice print without much troubles, you should follow the next steps:

1- Measure your table where the headset hanger is going to be and approximate the measurement to the higher millimetre(Ex: real measurement is 30,25mm, I shall approximate it to 31mm)

2- Select the main part that correspond to your height (Ex: I have an approximation of 31 mm so I'll have to print the 31mm main part)

3(optional)- In order to secure the hanger to the table, you have two ways. One is printing the joint and, with the hole in the superior part of the print, attach a piece of EVA rubber (for example) to the top inner part of the hook(as seen in the photo). The other option is to screw the hanger in the table through the hole. I personally prefer the first option as it makes no irreversible action in the table.

I hope that all is well explained. If you have any suggestions or questions don't hesitate in leaving it in the comments.