Lovesac Cup Holder Insert for Coffee Mugs

Created to solve the problem of putting a coffee mug in a lovesac cup holder. 

Two versions are included. 

An “ember” version that has a deeper setting and a “short” version that seems to work with all the normal ceramic coffee mugs in my house. Both fit snug inside my lovesac cup holders as shown in the pictures. If the print it too big for yours, measure your diameter and rescale the original models.

PETG is recommended for higher heat tolerance. You could also put some felt in the bottom for further insulation from mug heat but I haven't run into any issues so far.

Printer settings:

Printed at 0.28 layer height with 0.4mm nozzle

5 wall loops 

4 top and bottom layers

15% Archimedean cord infill (because why not, it looks cool)