Sturdy Kitchen Towel Holder

The model comes in 3 parts

Orientation for print is important. The Connection part needs to lay flat otherwise, it is not strong enough. Like it now holds up for a couple of months (even though I only used PLA).

The holder width is 27cm, the hook is 22mm, the *.step file should allow for easy adjustment.

Printed from PLA
* 0.4 mm nozzle
* 0.15 layer height
* I needed supports on the inner edges of the cutout, as otherwise, layer adhesion was not enough on the slight overhangs. (3mf file already should include those)