Sprite Extruder Cover

I don't know about you but I wouldn't say I like seeing the QR code and Ender logo on my Creality Sprite Extruder Pro. The direct drive's design doesn't leave much room for options to cover it up, however. So I went ahead and made my own.

This Sprite Extruder cover uses four 6mm x 2mm circular magnets to hold it in place. The magnets grab the existing screw heads and align the cover perfectly. The hole in the middle lines up with the extruder motor shaft. The top corners are angled off just like the stepper motor. The bottom of the cover is straight across but a little short to accommodate the cooling fan that is angled below it.

I printed mine in black and white to match my printer's colors. I also added this visualizer to complete the look! Did it in PETG with no supports but it should print well in just about any material.