Remix of the DIYRUZ USB CO2 Zigbee sensor enclosure. It allows reprogramming while being in the enclosure due to a specially made hole at the bottom giving access to Dupont male pin headers soldered into the PCB.
Also, the lid of the box is now connected using snap joints.
I'm not affiliated at all but for reference, the full GitHub page is here: https://github.com/diyruz/AirSense
I'll upload another version as well, less tall, allowing reprogramming using a pogo pin jig instead of Dupont pin connectors.
Due to the snap joints, one needs a reasonable well dialled in 3d printer.
Clearances are 0.2 mm, so make sure you don't end up with elephant's foot, or you'll have to clean up the edges of the lid to make it fit.
The author remixed this model.