Nevermore Duo mag mount base for Bambu Lab X1C

This is an additional base for the magnet mod Nevermore duo to fit a Bambulab X1C.  You will require the same parts as for the Voron V0 version, plus some VHB tape to stick it down. There is a cutout on the bottom to align with the “L” shaped protrusion on the right side of the printer, and a channel to route the wires rearward.

Be sure to run your wires so they don't rub on any moving parts, I run mine through a drilled hole in the rear panel. There is an open set of screw terminals on the psu, so you can run directly to that if you're using 24v fans.

Ill add some better photos later for clarity.

Enjoy!

Visit this model for the magnetic mount Nevermore filter

https://www.printables.com/model/428035-magnetic-mount-nevermore-duo-for-voron-v0