Kodama Trinus 3D Printer Mount/Adapter for UM2/2+ Low Friction Spool Holder

This is a mount/adapter to allow the use of the fantastic IRobertI Ultimaker 2/2+ low friction spool holder on the Trinus 3D printer.
You need to build the spool holder exactly as IRobertI has it setup, apart from the mount section. Instead of his mount, print this and use it to attach the holder to the back of the Trinus.

The green parts in the pictures are the IRobertI parts, and the brown/coffee filament is the Trinus mount and spacer. These are very basic parts and will print easily and relatively quickly (0.2mm with 100 percent infill takes about 45-60mins).

Once you have everything printed and all the required parts for the IRobertI spool holder assembled, just push the part with the screw section from the inside of the printer enclosure through the spool holder hole. The spacer part goes on the outside of the enclosure and is helpful in securing the mount(all that's touching the enclosure are the two parts here). An M6 nut goes on the end of the threaded rod inside the enclosure and tighten it and the far end of the spool holder until everything is tight and secure.

Original thing:
http://www.thingiverse.com/thing:235925

https://www.youtube.com/watch?v=w4r-\_bCf5Ko

Print instructions

Original thing:
http://www.thingiverse.com/thing:235925

https://www.youtube.com/watch?v=w4r-\_bCf5Ko

Print Settings

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: 100%