Desk cable organizer

A magnet based setup to organize your desk cables.
 

The Base can be attached to your desk in two different ways, with screws or with a printed clamp. The cable clips are printed in place and should not be under any stress when closed or opened, so they can be printed in PLA without deforming over time.

You will need 2 round magnets with a diameter of 10mm and height of maximum 3mm per clip. There are bases for 1-5 slots included. You will need to print the correct BaseTop for the amount of slots you want, and either the corresponding “Base-Clamp” or “Base-Screw” file.

To open a closed clip it's easiest to lever the tap with a small screwdriver (see last image)