Rugged Box for 18650 Batteries

This Rugged Box holds two 18650 batteries.
27
111
0
1440
updated October 25, 2023

Description

PDF

This Rugged Box holds two 18650 batteries.

 

Material: PETG 

Layer Height: 0.2mm 

Speed: 25 

Nozzle Temp: 235 

Bed Temp: 70

 

Needed for Allembly: 

2- Bottom/Top 

2- Hinges 

2- Clasps 

1- Seal A 

1- Seal B 

1- Label (Optional) 

4- 53mm pieces of filament to act as hinge pins

 

Instructions for Label: Print Label At single layer height (0.2mm) in center of bed.(Cura centers automatically). Turn bed heat back on immediately when finished. Remove skirt from print bed. Change to new filament color. Print Top Directly over Label centered on bed. (again, Cura centers automatically).

Note: If using BLTouch, when printing Top over the Label, it will be necessary to lower Z Offset by 0.2mm if the probe touches the label at the beginning of print.

I was told the Hinge is to wide to fit into the back side of the box and lid pieces. it needs to be resizwd to 17mm tall to fit properly before printing. I will update the file when I get a chance.

Model origin

The author marked this model as their own original creation.

License