Phone Stand

Yet another phone stand. There is nothing special about this phone stand, made it because I wanted to experiment a little more with creating models in blender.

Perhaps you find it useful, perhaps not. Either way, it's here.

Printed this with PLA Prusa Galaxy Black ( i can't get enough of this!)

Printed the model on it's side with paint on supports for the part of the stand that sticks out. Perhaps there is a more efficient way of doing it. If so, I will be happy to hear from you.

v2 is with a slightly hex different pattern (phone should be less than 9mm thick)

v2_12mm has a wider gap for holding thicker phones (e.g. if your phone has a cover)