Motherboard standoffs to replace cracked, broken or missing standoffs in the bottom of the breadbin cases. I made them extra wide on the bottoms for enough glue to surface contact. Sand down what is left of the broken standoffs. Screw the new sandoffs to the board, leaving just a little wiggle room for self leveling. apply glue to each standoff while the board is out of the case then put the mother board into the cash. Push firmly onto each standoff location. I glued one at a time as it was less chance for error that way. The stepped design is meant for the standoff to clear the diameter of the holes in the bottom shield and support the main board itself.
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Infill:
100%
Filament:
Overture PETG
Notes:
Post-Printing ============= Category: ComputerThe author marked this model as their own original creation. Imported from Thingiverse.