Commodore Video/Serial port covers

Snap in covers for the Video and Serial ports on Commodore Computers.

I have tested the round 64c style inside a Pixel Wizard and original 64c case. I also did test it in a C128 flat case, but its very tight. Might need some sanding or reduce the print size slightly to fit the C128 better.

The breadbin style I only tested on one style of the breadbin cases. I am not positive if it were the tall or short breadbin so your mileage may very depending on which breadbin you install this into. Again if the fit is too tight, you may try to sand the inside edge a bit or reduce the print size to get the desired tightness for you Commodore case.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

.20

Infill:

20%

Filament: Overture PETG your choice

Notes:

Be careful with old vintage plastic. If it feels too tight, try sanding or reducing the print size. I hate for you to break your commodore plastic. They just slightly snap into my cases and remove with my finger nails again.