BTT Pi TFT43 V2.0 Voron 2.4 touch screen case

Model Update:  3/18/23@2030 hrs Pacific.  After printing one of these, i realized that I made the counterbores for the screw holes too small in diameter.  The counterbores are now 5mm diameter and should clear all M2.5 socket head and button head cap screws.

Model Update: 3/19/23@1430.  Added clearance for the ribbon cable.

Model Update: 3/20/23@1820. Added a version of the housing that has a printable logo insert socket on the lower front.  

Model Update: 4/1/23.  Added honeycomb pattern to the sides.  Use supports.

Model Update: 4/6/23.  Increased the thickness of the material on the bottom, sides.  It was thin, and had two points where a hole would sometimes appear during printing.

Model Update: 4/8/23.  I found a minor asymmetry in the screen inlet. It is corrected.

I designed this to so that the BTT TFT43 V2.0 could be mounted to a Voron 2.4 and Trident.

Disclaimer:  I don't have a BTT TFT43 V2.0 to test this model with.  I designed it using dimensions from the internet and the incomplete CAD model from BTT's GitHub.  If you print this model and it doesn't fit,  message me and i'll make whatever changes are needed.

The housing mounts to the underside of the front 2020 rail, in the same manner as the skirts using 2 m3x8mm socket head cap screws.   The screen is held in by 4 M2.5x8mm socket head cap screws.  The accent pieces are secured with a couple drops of super glue.

There is a clearance cutout to allow space for the backlight adjustment wheel, but you will need to have your brightness adjusted to the level you want before assembly. After everything is assembled, you won't be able to access the adjustment wheel.

The step files are included, should anyone wish to modify the model to fit a different screen.