MagSafe bike mount

I had an old magsafe wallet and decided to not let the magnets go to waste.  I made this mount for my indoor trainer bike that I use in the winter.  This should be compatible with most bikes out there as long as the stem is longer than 50mm or so.  Holds to the bike with 3 zip ties

Assembly:

• Press the magnets into the top half of the print (no glue required, they are a press fit)
• glue the two halves together.  I made sure to avoid getting glue on the magnets incase I wanted to use them again.

I printed this in PLA as it will just be indoors. If you plan to have this outside, I would choose PETG.  The phone seems to hold well (I dropped the bike a couple times and it did not pop off), but I am not sure I would trust it on the road.