Fan shroud for i3S R5 for E3D Volcano

This is a reworked R5 Fan shroud for the e3d Volcano Hot end.
It is the only part you actually need to change a standard i3S hotend for a Volcano Hotend from E3D.

note the PINDA holder and rest for stability.

This has high level blowers to cool the top of the hotend, as well as the more usual part cooling holes.

Print instructions

The holes are pretty small so it's best to print on "0.15mm QUALITY" using Prusa slicer
Because it's near the hotend, use a material = to or better than your printing material, I use PET-G and print this with PET-G.
I've used a 15% infill but the big thing is this:
USE a brim and place this near the centre of the plate or the arms may peel away from the plate.