This is a very stable remote control plane, cheap and suitable for both beginners and advanced.
The plane structure is very strong (believe me, I crashed it a lot during testing😅)

You should print the plane with low weight pla. This material is 2.5 times lighter than pla! It is very important to make the plane strong and light as much as you can! You can use my .3mf files in order to achieve this goal😃

Assembly instructions:

Cut a strip of PLA and insert it through the holes (an example picture is attached)
Insert the PLA, which serves as a connector between each two pieces. Then stick with quick glue. Note that the glue seeps into the hole of the PLA

You need to calibrate the center of gravity by adding weight to the front of the plane (if necessary of course)
I added a medium stone to balance the plane better

Please support this design 😊

It took me a lot of time and hard work to design this plane, so if you can upload your results/give a like I will be grateful 😉

Also, if you can afford it please support me with the support button (yes I am asking for payment if you can pay😊). This will help me create more designs like this in the future.

List of needed parts:

📌 1 x Motor: 2212 980KV Motor

📌 1 x Brushless 30A ESC

📌 1 x 8060 propeller

📌 1 x LiPo Battery 11.1V 1000 mAh

📌 4 x Micro Servo (MG90)

📌 Radio Control

📌 4 x Servo Adaptor

📌 0.8 or 1.0 mm wire for the servos

📌 Lipo Battery Charger OR cheaper one

📌 Low weight PLA (I used esun's but you can by it also from colorFabb or 3dLabPrint)