Playseat Challenge Logitech G923 Pedal Mount

Sturdy crossbar mounting system that allows you to mount your pedal's directly to the Playseat Challenge bars.  I bolted my G923 with the 2xM6 Hex screws left over after setting up the chair.

Make sure you put the hex nuts in the slots so that they will not spin.

Hardware:

2x M3x5

2x M3x16

4x M3 hex nuts

2x M6 (Leftover from Playseat Challenge installation)

Print:

I printed all my parts using the default 0.20mm Speed mode.  Just lay the crossbar on the mostly solid face and the print 4x of each of the rod bracket types (top and bottom) and 2x crossbars.  No supports needed.