Needed a better way of holding coins for the arcade, or for the wash. Any coin that is similar to a quarter in dimensions should work, but probably not too much smaller as you would still need to fish it out with your thumb.
Small markings denote a dollar in quarters, larger markings around the sides denote 5 dollars. Total capacity should be around 11-13 dollars depending on the compression of the springs you place.
Required:
Printing:
Print one of each model for full assembly; .15mm or lower is recommended for layer-height. Large layer heights might make it difficult to screw the end-cap on or might cause issues getting quarters into the slot.
The author marked this model as their own original creation.