PI Trezor Case

I noticed a severe lack of cases for the Pi Trezor, and especially one that would fit my setup which uses the waveshare 1.3 inch OLED hat. This case is snap-fit, so your printer will need to be able to handle tight tolerances, but as long as you're not severely over extruding you should be ok.

Assembly is simple. Print the top, bottom, and 2 support pins. The support pins should fit into the holes in the hat (not in the pi itself), and the fit should be tight enough that they'll hold. Plug the hat into your pi, insert your SD card, and insert the whole assembly into the bottom piece. The indent in the bottom of the bottom piece should align with the solder points for the GPIO pins in your Pi. Place the top piece on (it should be pretty easy to figure out which direction it goes) and squeeze. I find it helps to try and get the top left and top right corners in first, and then attempt to get the other side in rather than going left to right or vice-versa.

If anyone has an Adafruit hat, please remix the top piece. Thanks!

If you want to build your own PiTrezor, follow the guide linked here!