Letter Holder

Here is a quick print I made on fusion 360 for a letter holder. Themed around a napkin holder I made.

It is sturdy enough to hold most basic letters and makes a great office or kitchen showpiece.

I printed this using Creality White PLA 1.75mm on an Ender 3 V2. The model uses approximately 46g of filament with 15% infill (all in the base). and takes around 4.75HRS to print. Rough dimensions are around 3.3in(H)x 4in(L)x 1.75in (W). Leaving around 1.5in to securely retain mail.

This print does retain a makers mark “Print By Kev” on the bottom of the print and is not visible unless flipped onto the side.

I would love to see photos of any makes and additionally any feedback about the print. This is one of my first prints from CAD to print.