Lightbar for Neptun 2/2s/3 and Ender 3

Hi.

I searched for a way to light up my printer.

My plan was to use some WS2812 RGB Led's. So i ordered 1m 144 RGB LED's from Aliexpress.

The only problem was, that i couldn't find a nice case for the LED's. So i designed my own.

The bar fits perfect under the top rail on my Neptun 2S.

There are 3 hooks for the bar that it can be mounted on the extrusion.

For better printability i designed the hooks separately and you just have to clue it in place.

Also you are free to move the cable through the extrusion.

For the lid i used transparent PETG with 0 top and bottom layers and 100% infil @ 20mm/s.

The structured PEI bed give it a good diffusion.

I used WS2812 addressable LED's from Aliexpress, controlled by an Arduino Nano and Klipper on Raspberry Pi.

Don't forget to like.