Canon LP-E6 double batteryholder

Please show some love and post your print. <3

This is a remix of Wojteks model. I wanted to have a very clear identification about the charging status of the batteries. The status is identified by the covering flags.

Parts are properly oriented, just drop them in your slicer and you are good to go.

Battery holder:
1. Battery_holder_org is the original version with slightly too long holding tabs for the batteries. The batteries can come off quite easily on their own.
2. Battery_holder_short has shorter holding tabs but this version is untested! (Please report if it works)

Flags:
The flags are meant to be printed multicolor. Mine are green (battery charged) on one side and red (battery discharged) on the other side. I sliced them with PrusaSlicer on an Ender 3 (Klipper) without any issue.

I printed mine in PLA with 20% infill.
 

If you like my work, I would appreciate a small donation:

I wanted to be able to see the charging status of the batteries.