https://www.amazon.com/JILINWEI-Workshap-Attachment-Grinder-Sharpening/dp/B0D9GVNKGH/138-3562544-7366640
Someone is selling it on Amazon.
Work Sharp Ken Onion Blade Grinder Riser 2.5 with slider. (thinner)
This is a new model of the version 2.0 of my riser, this time is thinner to make it closer to the belt width. :)
36
318
3
1943
updated
March 12, 2023
Makes
Comments
Nice design! My print has a bit of play on the piece that attaches to the grinder, so I may try to add a wedge or set screw to take out the play. Or potentially print 2-5% smaller. Thanks!
Hello! No. Don't reduce it. It's meant to be like that, just add a half wooden toothpick on the corner of the base, if you look it from the sude, top left corner and will not move anymore! Glad you like it. Sorry for my English I'm from spain
I would love to see this redesigned in a way that doesn't require supports. Using sloping transitions instead of 90* angles would help a lot. Making the right side of the stand itself flat would allow for print bed placement instead of using supports, too.
New design is more difficult to print due to the supports needed on the base. Settings have to be dialed for better support removal and some post print processing (Sanding). I had the best luck printing the sliders with the tops facing the bed.
@LiquidRetro yup I know that, but this was the only way... I wanted to keep the base like the original for better stability... The only way is with supports :( but fits well on your sharpener?
@DidacThomas_451368 Yes Fit is good, I prefer the original version myself, but options are always good.
View one more comment