Wheel Chock for Office Chair

This is a simple chock for keeping an office chair in place.

After getting myself a full "flight kit" for MS Flight Sim which included rudder pedals, I frequently had my chair rolling away from the desk during flight due to the pressure against the pedals. So, I quickly printed these simple wheel chocks to keep the chair in place during flight sessions.

I printed mine from TPU to provide better grip, but PLA or PETG should probably work just as well. No special print settings required.

The flat section was added intentionally so that the chair can roll onto it and keep the actual chock from sliding away. So, be sure it doesn't tear off when detaching from the build plate.

Print with layer height 0.15 mm to have two layers in the flat section.