2020 feet

These are some feet I printed up out of TPU to place under the 2020 base of my printer.
They've done well to reduce vibration take some noise from the regular printing motion.
I just place them into the slot on all corners and near the middle (my printer has 2040 on the X)

Print instructions

Category: 3D Printer Parts Summary

These are some feet I printed up out of TPU to place under the 2020 base of my printer.
They've done well to reduce vibration take some noise from the regular printing motion.
I just place them into the slot on all corners and near the middle (my printer has 2040 on the X)

Print Settings

Printer: Tevo Tarantula

Rafts: No

Supports: No

Infill: 10-30

Notes:

Infill depends on weight of printer. I used 25% on a 3d hex infill, but could go lower. Alternating infill types are nice because they absorb a bit more.