StepManiaX Stage Corner Brackets

This is my first model I've publicly released, I recommend printing one set at a time to make sure that the brackets will fit when produced on your printer. I have not applied any tolerance compensation as I haven't needed to on my current printer. Leave a comment if you have trouble and I'll gladly upload a version with more wiggle room.

---

Leave a comment with your chosen material and print settings!

---

Printing Instructions (4-panel)

Print with supports. You will need to print the following amounts, * can be either chamfered- or rounded- based on your preference / printer capability.

• *-inner.stl (2 per panel, 8 for a full set)
• *-outer-a.stl (1 per panel, 4 for a full set)
• *-outer-b.stl (1 per panel, 4 for a full set)

The chamfered version is recommended as it is an easier print and matches the design of the stage slightly more. Rounded is there as an option since it matches the original bracket designs slightly more, if your printer can do it.

Installation Tips

• Avoid over-tightening these brackets or they will be more prone to cracking
• Print with durable print settings as you will be stepping on these
• You may need to adjust your sensitivity after installing these brackets