Cable guide / clip / holder for 92, 120 and 140 mm PC fans

A simple cable guide for the most common sizes of PC fans (92, 120 & 140 mm), which easily clips in place. All sizes are available with one or two hooks per side.

The guide works best with thicker, sleeved cables. On fans with rubber anti-vibration pads on each corner (e.g. most Noctua fans), it might be helpful to remove those pads for the clips of the cable guide to fully engage.

Small disclaimer: The 140 mm variants are untested, but should work fine.

Print settings

• Layer height 0.16 mm
• Line width 0.42 mm
• 4 wall lines
• 100 % infill
• Supports enabled
• Set the support angle to 70° or higher to avoid supporting the round hooks

Approximate print times @ 60 mm/s: 92 mm 0:17 h / 120 mm 0:24 h / 140 mm 0:25 h