Minimal Funko Pop Shelf

While there is no shortage of Funko Pop organizers, shelves, etc., online, none of them were exactly what I wanted. So, I drew up this very simple design.

Printed at 100%, it fits snugly around a standard Funko Pop figure in box with one of the collapsible pop protectors. This was not designed to fit the hard box protectors.

I printed at 0.2mm 100% infill because I used translucent filament. If printing opaque, 20% infill is probably fine. There likely isn't all that big a difference in filament used, though.

I simply attached to the wall with 3M command strips. Funko Pop figures don't weigh much so you could use just about any sort of adhesive mounting you prefer.