MULTEA. Modular tea dyspenser.

The modular system allows you to hang it on the wall, furniture, place it on a shelf or table. Easy to move whole containers or individual drawers to the place of use. 

PLA printing. Print settings without additional options. Only additional perimeters are added and the fill angle is set to 0 (for the aesthetics of the print).
When printing the housing, you must stop printing at 38 mm to paste the magnet 5 mm in diameter and 3 mm in height.
After printing is finished, we stick round 3x1mm magnets inside the casing and on the back wall of the drawers. Be careful with the polarity of the magnets so that the drawers are slightly attracted to the center of the case.
The modules can be hung to the wall or furniture using a printed handle - a cross. It should be screwed with a half-round head screw. A screw can also be a screw fixing to the substrate (wall, furniture, ceramic tiles, etc.).
Remember that the head of a screw placed in the "cross" enters the housing and is attracted to the magnet placed in the housing (during printing). In the case of using a screw with a nut (M4x30), double-sided adhesive tape is used to fix the cross on the surface. Just in case, you can additionally apply a bit of strong glue under the tape to the printed cross.
 

From the front, in the middle of the housing, screw in the printed handle. Insert the pin (printed in the lying position) into the hole of the handle. It is used to strengthen the structure of the handle. The handle is printed with a thread to be screwed into the hole in the middle of the housing. Useful for sliding the entire box out of other modules placed on the wall.
 

I also attach print files with settings for Prusa MK3S.

You can change some settings according to your individual needs.