Star Wars Death Star Wall Diorama

Death Star Wall Diorama for 3 ¾ action figures.

Assembly instructions:

1. Print the parts (0.2mm) (no supports needed!)
2. Cut out a piece of white paper (size: 105mm x 55mm) 
3. Put the paper into the back of the front panel
4. Snap the back panel into place (see picture 5) 
5. Firmly press the parts into your desired floor piece

Three different floor pieces:

• No peg
• Peg for vintage Kenner Star Wars figures
• Peg for retro style Hasbro figures

I left a hole on the bottom of the back panel, for a future LED installation.

Created by me in Fusion 360.

Printed in Fossil Gray PLA.