Anet E16 E12 Y-axis Rod Holder

These are replacement brackets for the 8mm linear rod used on the Y axis of the Anet E10, E12, and E16.

They are open ended which allows you to use longer linear rods if needed. I have 500mm rods on mine and they sit flush on the front and back of the printer frame. You can use an M3 nut and screw (18mm+) to hold the rods in place and prevent movement if your print tolerances aren't tight enough to hold them from friction alone.

I recreated these from some old STL I found that doesn't seem to exist on thingiverse any longer and added countersunk holes so you can use shorter countersunk screws if you want.

You'll need 3 of the standard Y rod holders and 1 with the end stop. Print without supports, and clean up the holes with a drill if needed.

If you print with generated supports you'll likely weld the seam together with support material.

Print Settings

Printer:

Anet E16

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

40%+

Filament: