Carrera Go 1:43 Slotcar Chassis with slide guide for VW Touareg

This is a replacement chassis for the original one.
The original one has a simple pin for the slot and a magnet, so that it doesn't slide.

This is a chassis with a slide guide which allows you to drive over obstacles and slide, as there is no magnet.

Videos on Youtube
 

Instructions
Print every part once.

You have to cut the original pin from the body so that there is enough space for the slide guide.

Glue Touareg_chassis_part1 and Touareg_chassis_part2 together.
To mount the touareg_guide_mount to the chassis, I use a needle.

Use a spring from a pen to push the guide_mount with the slide guide to the rails when driving over obstacles. Cut a small mart out of it and try how it fits and works.

There is an extra hole in the chassis for the LED from the decoder. I modified all my cars with the decoder from the 1:32 Carrera Digital cars.

Parts to print
1x touareg_chassis_part1
1x touareg_chassis_part2
1x touareg_front_wheel_mount
1x touareg_rear_wheel_mount
1x touareg_guide_mount
1x touareg_motor_mount
1x touareg_pin
1x leitkiel

10x M2 screws
I use these ones
https://bit.ly/3UpC1tr

1x M3 10mm screw to mount the Chassis to the body
https://bit.ly/3Frxq5M