CR-10S X-Axis Cable Chain Cover Mount

Remix of: 2850432

Creality has updated the X Axis of the CR-10s and now includes a shroud from the factory. Sadly, this means the original design will not fit.

Print instructions

Remix of: 2850432

Creality has updated the X Axis of the CR-10s and now includes a shroud from the factory. Sadly, this means the original design will not fit.

I modeled this to be a drop in replacement. It is designed to be held in place by the bolt for the Z Axis guide wheel. You can reuse the stock M5 bolt as it should have 2mm sticking out the other side of the nut. Afterwards, it should be flush.

Post-Printing

Prerequisites

Tools Needed:

• 8mm Hex Wrench/Allen Key [For the M5 Bolt.]

• Wrench or Needle Nose pliers to hold the nut and to help realign during assembly.

Notes:

Before installing, you should have 2mm of the bolt sticking out of the nut, after installation it should be flush. You should not need to buy a longer M5 bolt.

How to Install

Step 1: Unscrew the bolt holding the top guide wheel of the Z Axis above the X Axis shroud. The bushing and wheel will fall when you take the bolt out. You will also need a small wrench or needle nose pliers to hold the nut on the opposite side.

Step 2: Place the part on top of the shroud and line up the screw hole.

Step 3: Thread the bolt back in and line up the bushing, wheel, and second bushing. I find it is easiest to use needle nose pliers to hold the bushing and wheel in place while you thread the bolt through.

Step 4: Tighten everything down and install the chain and complete your wire management.