Headphones Holder

Made with TinkerCAD. Just an extremely basic headphone holder for the side of my desk. The ones included with my desk were not wide enough for the headphones to easily be removed and put in place.

The two last pictures are how the headphones used to be. 

Made with IIID MAX PLA+ Night Gray.

100% Infill.

3/8/23 - Updated version “V2”.  3mm thick instead of 2mm and the ‘throat’ is wider where the headband goes.  Shown in the third and fourth photos.

4/26/23 - Went to print “V2” in PETG and noticed some corners with small gaps.  Eliminated them.  File is now “V2.1”