Kinda tricky but definitely a fun project to build 👍
I printed this model in PETG because it's more flexible than PLA. You should definitely go with .2 or lower layer height, I printed mine in .3 which makes the overhangs very rough. Further check for the color change. My first attempt failed because it was set to the wrong layer.
The assembly was straight forward even with different parts I used. Basically I used the stuff I had laying around (different controller, other charger, different Leds, etc. )😄 But I would recommend the parts from the video 😉.
What could be improved in the model is the way the parts are connected. In the video they used some kind of pins I don't know so I went with small screws. This works but some kind of snap in or bayonet lock would make it even more secure.
All in all a nice model and a fun project to build 👍 Thx a lot for sharing 😊
Kinda tricky but definitely a fun project to build 👍
I printed this model in PETG because it's more flexible than PLA. You should definitely go with .2 or lower layer height, I printed mine in .3 which makes the overhangs very rough. Further check for the color change. My first attempt failed because it was set to the wrong layer.
The assembly was straight forward even with different parts I used. Basically I used the stuff I had laying around (different controller, other charger, different Leds, etc. )😄 But I would recommend the parts from the video 😉.
What could be improved in the model is the way the parts are connected. In the video they used some kind of pins I don't know so I went with small screws. This works but some kind of snap in or bayonet lock would make it even more secure.
All in all a nice model and a fun project to build 👍 Thx a lot for sharing 😊