Adjustable Phone holder V1 (V2 available)

!!!
There is a V2 available, which is much sturdier, easier to assemble, more durable, and with much better mechanism. So DON'T PRINT THIS FILE! Instead, go with the V2 :) 
https://www.printables.com/model/226114-freely-adjustable-smarp-phone-holder-v2

!!!

This is a massive phone / tablet holder, witch has freely adjustable angle from 95° to 175°. It has nice, elegant design, and it is pretty compact, as You can see in the pictures. Compatible with phones / tablets thinner than 12.5 mm.

The mechanism of the phone holder is based on tight tolerances.

You can print it without any supports. For printing I recommend to use PLA, or some other stiff material. When printed out, for assembly You need a press or rubber mallet / a small hammer, and You have to press the three parts together, as You can see in the pictures.

I hope You enjoy my design :)

Print instructions

This phone / tablet holder is printable without supports.

For printing use PLA.

I recommend You to use 3 perimeters.

Recommended layer hight is 0.2mm, but You can also use finer settings.

Recommended infill is 20-30%.

For one stand You have to print these files:

holder_leg_1.stl
holder_leg_2_pl.stl OR holder_leg_clean.stl
stand.stl