Mouse holder

I found some Mouseholder-designs, but i prefer my holders with less material, less print time , thinner and somewhat curvy. Since there was no design i really liked, i designed it on my own to fit a Logitech G502X and a Cherry DW9500 Slim.  

I designed the back side to be open, so you can save filament and you can route a charging cable right through there, so your mouse can charge when you dont need it.

You can screw it under your desk or - preferably - glue it there with doublesided tape. If you still want to screw it and save screws, I added a central screwhole, so you can mount it with just one screw.

I added a little depressed area, so your mouse stays safe and you can pull it out by the sides or from the lower side.

The inner measurements are 81mm x 46mm x 122mm

No need for supports, but change the wall thickness to 3mm