BME280 extrusion mount for Voron 2.4 and Voron 0

BME280 is a temperature sensor, it also gives humidity and pressure. I use it as chamber temperature sensor in my Voron 2.4. 

There is several form factor, be careful to have the one on picture to use this mount
 

 (eg. https://www.amazon.com/KeeYees-Temperature-Humidity-Atmospheric-Barometric/dp/B07KYJNFMD)

Klipper Configuration

Plugged on Pi :

[mcu rpi]
serial: /tmp/klipper_host_mcu

[temperature_sensor chamber]
sensor_type: BME280
i2c_address: 118
i2c_mcu: rpi
i2c_bus: i2c.1

Plugged on BTT Octopus (PA8/PA9):
i2c_bus is not well documented , you can find it in source of klipper: for example BTT Octopus has STM32 cpu , look at https://github.com/Klipper3d/klipper/blob/master/src/stm32/i2c.c

[temperature_sensor chamber]
sensor_type: BME280
i2c_address: 118
i2c_bus: i2c1a

Bill of materials