Handle for 24oz Thermos

Thermos 24oz handle.  Printed with ASA.  Still figuring out what the best angle to print this at.  I printed this with flat with organic supports and 6 walls at 15 infill.  It is a little tight so I would widen it on PrusaSlicer about 1% or 2% and see if that loosens it up.  I will try editing the file later but right now making the handle wider on the slicer is easier than doing it in Fusion 360.  You will need a stainless steel 3mm rod approximately 42mm long.  I bought some on Amazon for about $6.

Update.  I was able to make the handle 1mm wider.  I have not printed it yet to try it out.  I will print it in PLA to test the fit and I will try another angle to print it as.  The original works perfectly well but it is stiff. I would like to to be a bit looser.