Darth Maul's Half Lightsaber

I designed Half of Maul's Dual Lightsaber from the Clone wars, Season 5 in Fusion 360. I would recommend for the blades that you use PETG with no cooling to make the blades as strong as possible. As for the hilt, I used some silver PLA. The pommel screws into the hilt. This is all printed on the Ender-3. These design feature magnets so that you can walk with a lightsaber as they do in the trilogy. You will need two magnets which have the following dimensions; 30mm x 10mm x 5mm. The blade extends to about 900mm.

Print settings:

0.2 mm Layer Height

10% Infill

3 walls

3 Bottom&Top Layer

BuildPlate Support