Outsunny Awning Storage Bracket

If you live in a climate where you get no use from your awning for 8 months of the year you may decide to store your awning inside. This helps preventing the cloth from becoming destroyed by the sun's UV's.

There are 2 files. The larger one you will need at least 2 printed. I recommend printing 1 for each bolt holding it in its outside location. This will give you a place to keep your bolts and not misplace them by the spring. If you have a rather wide awning you can add extra support with the smaller file. These have been printed with a hole large enough for a #8 screw long enough to grab onto a wall stud.

This was designed for the dimensions of the Outsunny brand of awning but may work on others. It is not designed to mount the awning in an extended manner. It will only hold the retracted weight of the awning. If you extend the awning you will split the print at the layer seam and it will fall and damage your awning and anything below it. You have been warned!

*** Update: Added a clip to hold the awning crank if you choose not to hang it off the awning itself.

Print Settings

Printer:

Two Trees Sapphire Pro

Rafts:

Supports:

No

Resolution:

Infill:

20%

Filament:

White

Notes:

I took measurements from the model of awning I own and created a crude bracket. It was designed in Fusion 360.