Folding Phone Stand - Hangable

Wanted something to hang over my car's radio to watch stuff while parked. I printed the original model in TPU-95 to avoid scratching my screen.  I modded the stand part to be wider and open but noticed also that the model had no bottom supports.   

Remixed this model to include a brace to keep the swingable base from extending more than 90 degrees and then duplicated and relocated the hanger part so it could hold the brace in better.   Yes, i did a lot of this work with TinkerCad

In addition to printed parts (6 total) this also needs 3 lengths of PLA to use as pins.   

The Full model can be printed to include all the parts.   I used this file, sliced with Cura 5.3 Alpha

• Draft 0.20
• 3 walls
• 228 temp
• 65 bed
• Top Bottom Pattern - Zig Zag
• 20% infill Zig Zag