Gigabyte G1 Sniper Z87 I/O Shield

❣I had come into a Gigabyte G1 Sniper Z87 Motherboard, unfortunately it was without the I/O shield. I modeled this one up as a replacement to use the board in a build.

Unfortunately, I didn't take any pictures of it installed while I had it, but I figured I would upload this model incase it helps someone else in the future.

I did print it and tweak the model a couple times, so you should have a good fit. The motherboard holds it into position, and it's not designed to snap into the case like a normal I/O shield.

Don't forget to like! And post your make, get your prusameters!