Milwaukee M18 Battery adaptor for Falke

To make this work you have to take apart the Falke tool and get to the mainboard.

There are 4x1,8mm hole so you can use filament as guide and glue it together or you can drill holes to fit screws. I used m4x40 bolt and cut off the excess.

Print instructions

Print all models without support, increase perimter count until you have a solid.

Wiring

First disassemble the hedge cutter so you have acess to the mainboard

Find B+ and remove it from the board and solder a wire and make a hole so you can take the wire outside to the Milwaukee battery adaptor

Connect the -(Negative)pole on the first battery to the -(Negative)pole on the Falke machine

Connect the +pole on the Milwaukee pole to the -(Negative)pole on the second M18 battery.

Connect the +pole on the second battery to the B+ wire you soldere off the mainbord.

Now the machine should run!

Assembly

Use blue spade connectors with the blue cut off, glue or bolt together the two parts for the battery adaptor

Fit the Falke adaptor inside the slot for the batteries, fit the wiring, and glue the two battery adaptors to the Falke adaptors

Finnished