Box with lockable sliding lid

READ BEFORE PRINTING!

This is a non-commercial print, this means you are not allowed to sell files or prints of this model.

------------------------------------------------------

What is it for?

Anything really… It's essentially a box with a sliding lid and a locking clasp that securely snaps the lid in place. 

I made this vesion of the box to fit a standard MTG EDH-deck, but ofc it doesn't stop you for using it for anything else. 

I made another version of this box for my camera to have a robust and protective case when I'm travelling for example. The inside and outside measurements can be found below.

------------------------------------------------------

How does it work?

• The lid is “print in place” together with the clasp. This means that you only need to print two models.
• You slide the lid from the slide and snap the lid in place with the clasp.

------------------------------------------------------

How to print:

• Do not use supports! Both models are supposed to be printed without any supports.
• Make sure your printer can achieve 0.3mm tolerances before printing. If not, your hinge will fuse.
• Use some force when cracking the clasp loose. It will likely be stuck, but should be able to break loose without destroying the clasp.

------------------------------------------------------

Measurements:

Inside: 

• Width: 70mm
• Length: 94mm 
• Height: 70mm

Outside: 

• Width: 76mm
• Length: 109mm 
• Height: 76mm