OrangePi 2 Zero HSW Mount

Inspired by a RaspberyPi Honeycomb Storage Wall mount.

This model should fit into the quad insert for the HSW. It's a very snug fit into the quad insert, but it will allow for an OrangePi Zero 2 to mount on it, or any other OrangePi with the same dimensions as the Zero 2. 

It has cutouts for M3 nuts to be embedded, but the bolt holes are small enough that nuts will be optional.

Printed in PLA+ with 0.2mm layers. Infill can be low since there isn't a lot of weight. No supports required.