S-180-12 PSU Cover

This is a remix to accommodate a Huaconn HC-99-F5 kettle plug (see 3rd image).

Print up right (as shown in 2nd image) with support required to the large plug opening only, unless your bridge settings are up to the task.

Cables exit through the large round hole on the left side.

Additional parts required:

2No M3 x 10mm Bolts (to attach cover to PSU)
2No M4 x 20mm Bolts (to attach kettle plug to cover)
1No M3 Nut
2No M4 Nuts

Nuts are a tight fit to ensure they remain in place, but will push in with a bit of effort.