FLsun V400 Caliper Holder

I wanted a place to hold my caliper when needed, so I thought I would design a holder for the V400. Just like my tool holder, it's better to slide it from the top as opposed to spreading the arms too wide (I used the same arm radius / connector).

This was done with Hatchbox PLA, .3 layer height, Gyroid infill @ 20% (just to give it extra strength), no supports or brim needed - easy print). The holder works great for a standard caliper. It took about 20 minutes to print.

Feel free to make suggestions. 

Update: someone PM'd me, who clearly has OCD (LOL), printed the model, and says the caliper is a little crooked hanging down because the thumb adjuster sits a tad higher. I have done a modification to the model to add 2.4MM on the wall under the thumb screw to make it even(er). Load Version 3 for the updated model.